Important Information On Refinishing Hardwood Floor Outlined
If you are the proud owner of wooden floors then you must be aware that if you take care of them properly then they can last years but this is usually not the case for the finish. Bringing your floor to look new again in most instances will involve sanding it down so that you can take off the entire top layer, re-staining it then glossing it again. This process can only be performed a few times on wood so if you can avoid sanding the wood. Refinishing hardwood floor is an important process.
If the layers on your floor are worn out but the screen looks like it is alright then you may opt to screen the floor. You do this by taking out the gloss on the wood and it is usually easy to do. This will ensure that you use the floors for years to come.
You should get a floor buffer for the job. If you do not have one considers hiring it to save on costs. Load it with the heaviest screening pad. Start buffing the floors and run the machine in the direction the boards are facing. Work your way towards all the edges carefully taking off the top layer then after you are done screen the floors and vacuum thoroughly.
The heavier buffer should be replaced by a more medium one for a lighter touch. This will be used to work on the floors in a similar manner as the first time you did it. The remainder of the gloss should be taken away by this and you can finish it off by vacuuming.
Take out the midpoint buffer and put on the finest buffer you have so that the 3rd and final buff will be on a finer scale. Follow it up by thoroughly cleaning and vacuuming the entire area. This will yield a dull wooden floors since you will have completely taken off the gloss. But the stain that was there will not be affected.
Be sure that you have the sufficient amount of polyurethane for the job at hand. This will ensure that you retain your momentum once you start and not have to rush to the shops to get it. Start with those areas that are far away from the exit and pour it on the boards in adequate amounts.
The applicator should be put in the gloss, pull it rearwards and run it over the wooden boards. You should then go through the entire process a second time and take more care. Leave the area for about 8-10 hours to dry well.
Buff the gloss with fine sandpaper after it has completely dried but make sure that you use a little amount of pressure with your hands. You will then have to vacuum the area again to make sure that it is completely clean. Polyurethane will then be applied and let to dry before you sand the floor again and vacuum it further.
You will also need to apply a 3rd coat of polyurethane so that you have the finest finish possible on your floors. Do not go in the areas you have worked on for at least 48 hours so that you do not spoil all the hard work that you have done on the floors. The main objective for doing all that hard work was to ensure your floors are sparkling. The process of refinishing hardwood floor is obviously an important one.
